P24AD — EGR cooler coolant pump: feedback circuit high
| Meaning | Besides the command wire, the EGR cooler pump can send the control module a signal about its own operation. The module read too high a voltage on that feedback signal. The code concerns the feedback wire or the pump; the exact meaning of this signal depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
EGR limited or disabled, with higher emissions
Abnormal coolant temperature
Loss of power in some conditions
No obvious symptom at first
Pump seems to work but is reported as faulty
Common causes
Signal wire broken or disconnected
Damaged or corroded connector
Pump with faulty internal electronics
Control module input problem, which is rare
What to do
How to read code P24AD
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24AD starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (AD) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24AD mean?
EGR cooler coolant pump: feedback circuit high. Besides the command wire, the EGR cooler pump can send the control module a signal about its own operation. The module read too high a voltage on that feedback signal. The code concerns the feedback wire or the pump; the exact meaning of this signal depends on the manufacturer.
Can I keep driving with code P24AD active?
With caution: limp mode possible, have it checked soon
Common causes — P24AD
Feedback wire touching the supply voltage Signal wire broken or disconnected Damaged or corroded connector Pump with faulty internal electronics Control module input problem, which is rare
How do you fix code P24AD?
Check the pump connector and wiring, especially the signal wire, looking for abnormal contacts or broken wires. If the pump turns normally, the problem is probably in the signal and not in the circulation, but a workshop measurement is needed to be sure. You can use the car with care, keeping an eye on the coolant temperature.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24AC — EGR cooler coolant pump: feedback circuit low
- Next code: P24AE — Particulate matter sensor: circuit fault
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible