P24B0 — Particulate matter sensor: circuit signal too low
| Meaning | The control module read a lower voltage than expected in the circuit of the particulate matter sensor, located in the exhaust after the filter. This usually points to a wire shorted to ground, a missing supply or a faulty sensor. The sensor cannot monitor the filter while the problem remains. |
| Family | Powertrain (P) |
Typical symptoms
No obvious change in driving
Possible limp mode on some models
Regenerations managed less precisely
Possible failure of the emissions inspection
Common causes
Connector corroded or wet
Sensor supply missing or weak
Particulate matter sensor faulty
Wiring damaged by exhaust heat
Sensor control unit fault, which is rare
What to do
How to read code P24B0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24B0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (B0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24B0 mean?
Particulate matter sensor: circuit signal too low. The control module read a lower voltage than expected in the circuit of the particulate matter sensor, located in the exhaust after the filter. This usually points to a wire shorted to ground, a missing supply or a faulty sensor. The sensor cannot monitor the filter while the problem remains.
Can I keep driving with code P24B0 active?
With caution: limp mode possible, have it checked soon
Common causes — P24B0
Sensor wire touching ground Connector corroded or wet Sensor supply missing or weak Particulate matter sensor faulty Wiring damaged by exhaust heat Sensor control unit fault, which is rare
How do you fix code P24B0?
Check the sensor connector and wiring, which run near the hot exhaust and are easily damaged. If they are fine, the supply and signal need to be measured at a workshop. The fault does not usually stop you driving, but it is best not to wait too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24AF — Particulate matter sensor: signal out of range or...
- Next code: P24B1 — Particulate matter sensor: circuit signal too high
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible