P24CC — AdBlue tank cap switch signal out of range
| Meaning | The control unit is receiving a signal from the AdBlue tank cap switch that does not match what it expects. The circuit is electrically present, but the value or behaviour is not plausible. It can come from the cap, the switch or the wiring. |
| Family | Powertrain (P) |
Typical symptoms
Dashboard message about the cap or tank
Emissions system fault warning
Message does not clear after refilling AdBlue
No obvious driving symptoms
Common causes
Worn or dirty cap switch
Crystallised urea residue on the filler neck
Corroded connector contacts
Wiring or control unit problem (less common)
What to do
How to read code P24CC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24CC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (CC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24CC mean?
AdBlue tank cap switch signal out of range. The control unit is receiving a signal from the AdBlue tank cap switch that does not match what it expects. The circuit is electrically present, but the value or behaviour is not plausible. It can come from the cap, the switch or the wiring.
Can I keep driving with code P24CC active?
With caution: limp mode possible, have it checked soon
Common causes — P24CC
Cap fitted badly, not original, or deformed Worn or dirty cap switch Crystallised urea residue on the filler neck Corroded connector contacts Wiring or control unit problem (less common)
How do you fix code P24CC?
Check that the cap is the correct one, properly closed and clean, and look for white crystals around the filler neck. If the code returns, have the switch checked: it is not a serious mechanical fault, but it should not be ignored.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24CB — AdBlue tank cap switch circuit fault
- Next code: P24CD — AdBlue tank cap switch signal too low
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible