P24DC — Reductant purge control valve B performance problem
| Meaning | The control module has detected that purge valve B of the reductant system (the AdBlue/urea fluid used by the SCR system) is not responding as expected to the commands it receives. The circuit is not necessarily broken: the problem is that the valve's response is not correct. The exact meaning and location of valve B can differ between manufacturers. |
| Family | Powertrain (P) |
Typical symptoms
Fault message on the dashboard related to the SCR system
Possible power limitation on some vehicles
Unusual AdBlue consumption
Higher nitrogen oxide emissions than normal, not noticeable while driving
Common causes
Dirt or urea crystals in the valve or lines
Blocked or partly frozen reductant line
Power supply or ground problem at the valve
Fault in the dosing module or the control unit
What to do
How to read code P24DC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24DC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (DC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24DC mean?
Reductant purge control valve B performance problem. The control module has detected that purge valve B of the reductant system (the AdBlue/urea fluid used by the SCR system) is not responding as expected to the commands it receives. The circuit is not necessarily broken: the problem is that the valve's response is not correct. The exact meaning and location of valve B can differ between manufacturers.
Can I keep driving with code P24DC active?
With caution: limp mode possible, have it checked soon
Common causes — P24DC
Purge valve responding slowly or incompletely Dirt or urea crystals in the valve or lines Blocked or partly frozen reductant line Power supply or ground problem at the valve Fault in the dosing module or the control unit
How do you fix code P24DC?
Have the code read with a tool that shows live data from the valve, and check the condition of the AdBlue lines and fittings. Don't leave it too long: on many vehicles an SCR fault can lead to reduced power or a no-start condition after a certain distance.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24DB — AdBlue purge valve B circuit open or faulty
- Next code: P24DD — Reductant purge control valve B circuit low
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible