P24DE — Reductant purge control valve B circuit high
| Meaning | The control module detects a voltage that is too high on the circuit of purge valve B of the reductant system (the AdBlue used by the SCR system). This usually points to an open circuit, a loose contact or a short to the power supply. Valve B can be a different valve from one make to another. |
| Family | Powertrain (P) |
Typical symptoms
SCR system fault message
Possible power limitation
AdBlue system purge missing or incomplete
No obvious driving symptoms apart from the warning lights
Common causes
Wire broken or shorted to the power supply
Open valve coil
Faulty circuit ground
Fault in the control unit that drives the valve
What to do
How to read code P24DE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24DE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (DE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24DE mean?
Reductant purge control valve B circuit high. The control module detects a voltage that is too high on the circuit of purge valve B of the reductant system (the AdBlue used by the SCR system). This usually points to an open circuit, a loose contact or a short to the power supply. Valve B can be a different valve from one make to another.
Can I keep driving with code P24DE active?
With caution: limp mode possible, have it checked soon
Common causes — P24DE
Valve connector unplugged, loose or corroded Wire broken or shorted to the power supply Open valve coil Faulty circuit ground Fault in the control unit that drives the valve
How do you fix code P24DE?
Check the valve connector and wires, making sure the contacts are fully seated and clean. This is not a fault to ignore for long: if the SCR system does not work, many vehicles limit engine power.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24DD — Reductant purge control valve B circuit low
- Next code: P24DF — Reductant purge control valve B stuck open
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible