Skip to content
Fault code dictionary (DTC)

P2550 — Torque management request "B": low signal

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine control unit reads a lower than expected voltage on the torque request signal "B". This can be a wire shorted to ground, an open circuit or a fault in the module that generates it. The setup depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Harsh gear changes
Loss of power
Abnormal throttle response
Other lights related to transmission or traction control

Common causes

Signal wire shorted to ground
Corroded connector or loose terminals
Broken or chafed wiring
Fault in the control unit generating the request
Missing supply or ground at the module
Internal engine control unit fault, which is rare

What to do

Inspect the signal wiring and connectors and measure the voltage with a meter, also reading the codes from the other modules. If you notice odd shifting or power loss, don't put it off.

How to read code P2550

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2550 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (50) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2550 mean?

Torque management request "B": low signal. The engine control unit reads a lower than expected voltage on the torque request signal "B". This can be a wire shorted to ground, an open circuit or a fault in the module that generates it. The setup depends on the manufacturer.

Can I keep driving with code P2550 active?

With caution: limp mode possible, have it checked soon

Common causes — P2550

Signal wire shorted to ground Corroded connector or loose terminals Broken or chafed wiring Fault in the control unit generating the request Missing supply or ground at the module Internal engine control unit fault, which is rare

How do you fix code P2550?

Inspect the signal wiring and connectors and measure the voltage with a meter, also reading the codes from the other modules. If you notice odd shifting or power loss, don't put it off.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes