P2551 — Torque management request "B": high signal
| Meaning | The engine control unit reads a higher than expected voltage on the torque request signal "B". This usually points to a short to supply, a lost ground or a fault in the module sending the request. Details depend on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Harsh or badly timed gear changes
Loss of power
Odd pedal response
Possible limp mode
Common causes
Missing ground at the module or signal
Damaged or corroded connector
Fault in the control unit sending the request
Wiring damaged by chafing or moisture
Internal engine control unit fault, which is rare
What to do
How to read code P2551
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2551 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (51) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2551 mean?
Torque management request "B": high signal. The engine control unit reads a higher than expected voltage on the torque request signal "B". This usually points to a short to supply, a lost ground or a fault in the module sending the request. Details depend on the manufacturer.
Can I keep driving with code P2551 active?
With caution: limp mode possible, have it checked soon
Common causes — P2551
Signal wire shorted to supply voltage Missing ground at the module or signal Damaged or corroded connector Fault in the control unit sending the request Wiring damaged by chafing or moisture Internal engine control unit fault, which is rare
How do you fix code P2551?
Check the ground, connector and signal wiring, then verify the values with a scan tool and read the codes from the other modules. If the transmission or engine behaves oddly, have it looked at soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2550 — Torque management request "B": low signal
- Next code: P2552 — Throttle/fuel inhibit circuit fault
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault