P255C — PTO speed selector 2 circuit: signal too low
| Meaning | The control unit detected a voltage that is too low in the circuit of the second power take-off (PTO) speed selector. It usually points to a wire shorted to ground or a shorted selector. It mainly concerns commercial vehicles. |
| Family | Powertrain (P) |
Typical symptoms
PTO speed cannot be selected
Check engine light on
Equipment stops or runs jerkily
Normal driving without PTO
Common causes
Shorted selector
Connector with moisture
Chafed wiring
Control unit failure (rare)
What to do
How to read code P255C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P255C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (5C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P255C mean?
PTO speed selector 2 circuit: signal too low. The control unit detected a voltage that is too low in the circuit of the second power take-off (PTO) speed selector. It usually points to a wire shorted to ground or a shorted selector. It mainly concerns commercial vehicles.
Can I keep driving with code P255C active?
With caution: limp mode possible, have it checked soon
Common causes — P255C
Selector wire shorted to ground Shorted selector Connector with moisture Chafed wiring Control unit failure (rare)
How do you fix code P255C?
Check the selector's wiring and connectors, looking for chafed or damp wires. Don't use the PTO until the fault is fixed.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P255B — PTO speed selector 2: implausible signal
- Next code: P255D — PTO speed selector 2 circuit: signal too high
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault