P255D — PTO speed selector 2 circuit: signal too high
| Meaning | The control unit detected a voltage that is too high in the circuit of the second power take-off (PTO) speed selector. It usually points to a broken wire, an unplugged connector or contact with a power supply line. |
| Family | Powertrain (P) |
Typical symptoms
PTO speed cannot be selected
Check engine light on
Unstable equipment
Normal driving without PTO
Common causes
Broken wire
Faulty selector
Wiring touching a power supply line
Control unit failure (rare)
What to do
How to read code P255D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P255D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (5D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P255D mean?
PTO speed selector 2 circuit: signal too high. The control unit detected a voltage that is too high in the circuit of the second power take-off (PTO) speed selector. It usually points to a broken wire, an unplugged connector or contact with a power supply line.
Can I keep driving with code P255D active?
With caution: limp mode possible, have it checked soon
Common causes — P255D
Unplugged or corroded connector Broken wire Faulty selector Wiring touching a power supply line Control unit failure (rare)
How do you fix code P255D?
Start with the selector's connectors and wiring. Avoid using the connected equipment until the circuit is sorted.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P255C — PTO speed selector 2 circuit: signal too low
- Next code: P255E — PTO speed selector 2: intermittent signal
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault