P255E — PTO speed selector 2: intermittent signal
| Meaning | The signal from the second power take-off (PTO) speed selector comes and goes or is unstable. It is usually a contact that is lost due to vibration, moisture or wear. |
| Family | Powertrain (P) |
Typical symptoms
PTO speed changes by itself
Check engine light that comes and goes
Unstable equipment
Problem that appears with vibration
Common causes
Partially broken wire
Worn selector
Wiring chafed by vibration
Moisture in the circuit
What to do
How to read code P255E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P255E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (5E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P255E mean?
PTO speed selector 2: intermittent signal. The signal from the second power take-off (PTO) speed selector comes and goes or is unstable. It is usually a contact that is lost due to vibration, moisture or wear.
Can I keep driving with code P255E active?
With caution: limp mode possible, have it checked soon
Common causes — P255E
Loose or corroded connector Partially broken wire Worn selector Wiring chafed by vibration Moisture in the circuit
How do you fix code P255E?
With the engine off, carefully wiggle the wiring and connectors to see if the problem shows up, and have the contacts checked. Avoid the PTO until the signal is stable.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P255D — PTO speed selector 2 circuit: signal too high
- Next code: P255F — A/C request A circuit: implausible signal
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault