P2570 — Ozone reduction catalyst temp sensor signal too high
| Meaning | The control unit read a higher voltage than normal on the temperature sensor circuit for the ozone reduction catalyst. This special coating is fitted on only some models. The code points to an electrical problem in the sensor or its wiring, such as a broken circuit or a short to power. |
| Family | Powertrain (P) |
Typical symptoms
Usually no obvious driving symptoms
Other codes related to the sensor may be stored
Possible failure at the inspection
Common causes
Corroded connector or poor contact
Faulty temperature sensor
Short to power in the wiring
Internal control unit problem (rare)
What to do
How to read code P2570
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2570 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (70) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2570 mean?
Ozone reduction catalyst temp sensor signal too high. The control unit read a higher voltage than normal on the temperature sensor circuit for the ozone reduction catalyst. This special coating is fitted on only some models. The code points to an electrical problem in the sensor or its wiring, such as a broken circuit or a short to power.
Can I keep driving with code P2570 active?
With caution: limp mode possible, have it checked soon
Common causes — P2570
Sensor wire broken or unplugged Corroded connector or poor contact Faulty temperature sensor Short to power in the wiring Internal control unit problem (rare)
How do you fix code P2570?
First check the sensor connector and wiring for breaks, corrosion or damaged wires. It will not stop the car, but the warning light should be checked reasonably soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P256F — A/C request B signal out of range or implausible
- Next code: P2571 — Ozone reduction catalyst temp sensor signal interm...
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault