P257B — Vacuum reservoir control circuit signal too low
| Meaning | The control unit measured a lower voltage than normal on the vacuum reservoir control circuit, typical of a wire touching ground. The vacuum reservoir serves the brake booster and other actuators. Which component is controlled depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Brake pedal harder than usual
Vacuum-operated actuators working poorly
Possible other codes on the circuit
Common causes
Shorted solenoid
Wet or damaged connector
Wiring rubbed or pinched
Control unit problem (rare)
What to do
How to read code P257B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P257B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (7B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P257B mean?
Vacuum reservoir control circuit signal too low. The control unit measured a lower voltage than normal on the vacuum reservoir control circuit, typical of a wire touching ground. The vacuum reservoir serves the brake booster and other actuators. Which component is controlled depends on the manufacturer.
Can I keep driving with code P257B active?
With caution: limp mode possible, have it checked soon
Common causes — P257B
Control wire touching ground Shorted solenoid Wet or damaged connector Wiring rubbed or pinched Control unit problem (rare)
How do you fix code P257B?
Check the solenoid wiring and connector for damaged wires and moisture. If the brake pedal is harder than usual, have it checked right away for safety.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P257A — Vacuum reservoir control circuit open
- Next code: P257C — Vacuum reservoir control circuit signal too high
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault