Skip to content
Fault code dictionary (DTC)

P257C — Vacuum reservoir control circuit signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit measured a higher voltage than normal on the vacuum reservoir control circuit, typical of a short to power or a missing ground. The vacuum reservoir serves the brake booster and other actuators. Which component is controlled depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Brake pedal harder than usual
Vacuum-operated actuators working poorly
Possible other codes on the circuit

Common causes

Short to power in the wiring
Missing or corroded solenoid ground
Faulty solenoid
Damaged connector or poor contact
Control unit problem (rare)

What to do

First check the ground, connector and wiring of the vacuum solenoid. If the brake feels harder or less effective, have it checked right away for safety.

How to read code P257C

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P257C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (7C) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P257C mean?

Vacuum reservoir control circuit signal too high. The control unit measured a higher voltage than normal on the vacuum reservoir control circuit, typical of a short to power or a missing ground. The vacuum reservoir serves the brake booster and other actuators. Which component is controlled depends on the manufacturer.

Can I keep driving with code P257C active?

With caution: limp mode possible, have it checked soon

Common causes — P257C

Short to power in the wiring Missing or corroded solenoid ground Faulty solenoid Damaged connector or poor contact Control unit problem (rare)

How do you fix code P257C?

First check the ground, connector and wiring of the vacuum solenoid. If the brake feels harder or less effective, have it checked right away for safety.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes