P2587 — Turbo boost control position sensor B range/performance
| Meaning | The control unit is getting from position sensor B of the turbo boost control a value that does not match the command given or other readings. The sensor responds, but the data does not add up. The problem is often mechanical, for example a part that does not move as it should. |
| Family | Powertrain (P) |
Typical symptoms
Boost pressure too low or too high
Loss of power or jerking
Engine in limp mode
Uneven throttle response
Common causes
Position sensor out of calibration or failed
Linkage or control loose or worn
Leaks in the pipes or vacuum control
Wiring with abnormal resistance
What to do
How to read code P2587
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2587 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (87) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2587 mean?
Turbo boost control position sensor B range/performance. The control unit is getting from position sensor B of the turbo boost control a value that does not match the command given or other readings. The sensor responds, but the data does not add up. The problem is often mechanical, for example a part that does not move as it should.
Can I keep driving with code P2587 active?
With caution: limp mode possible, have it checked soon
Common causes — P2587
Turbo actuator or vanes stuck with soot Position sensor out of calibration or failed Linkage or control loose or worn Leaks in the pipes or vacuum control Wiring with abnormal resistance
How do you fix code P2587?
Have the actuator and its mechanism checked for free movement and no play. Avoid pushing the engine hard until it is checked, because uncontrolled pressure can damage the turbo.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2586 — Turbo boost control position sensor B circuit faul...
- Next code: P2588 — Turbo boost control position sensor B circuit volt...
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault