P2588 — Turbo boost control position sensor B circuit voltage too low
| Meaning | The control unit is reading a lower than normal voltage on the circuit of position sensor B of the turbo control. Usually the wire is grounded or the sensor is shorted. Without a reliable position, turbo pressure is not regulated well. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Turbo not pushing as it should
Engine in limp mode
Slow response when accelerating
Common causes
Position sensor shorted or failed
Connector with water or corrosion
Wiring crushed or burned by heat
Control unit fault (rare)
What to do
How to read code P2588
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2588 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (88) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2588 mean?
Turbo boost control position sensor B circuit voltage too low. The control unit is reading a lower than normal voltage on the circuit of position sensor B of the turbo control. Usually the wire is grounded or the sensor is shorted. Without a reliable position, turbo pressure is not regulated well.
Can I keep driving with code P2588 active?
With caution: limp mode possible, have it checked soon
Common causes — P2588
Signal wire grounded by damaged insulation Position sensor shorted or failed Connector with water or corrosion Wiring crushed or burned by heat Control unit fault (rare)
How do you fix code P2588?
Check the sensor wiring and connector, looking for chafed or burned wires. Do not drive for long with reduced power and have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2587 — Turbo boost control position sensor B range/perfor...
- Next code: P2589 — Turbo boost control position sensor B circuit volt...
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault