P258D — Vacuum pump A control circuit voltage too high
| Meaning | The control unit is reading a higher than normal voltage on the control circuit of vacuum pump A. This usually indicates a broken wire or contact with a power supply. The pump may not be getting the right command. |
| Family | Powertrain (P) |
Typical symptoms
Harder brake pedal
Less assisted braking
Pump not starting or running all the time
Weak vacuum-operated functions
Common causes
Corroded terminals
Pump failed
Wire in contact with a power supply
Control unit fault (rare)
What to do
How to read code P258D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P258D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (8D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P258D mean?
Vacuum pump A control circuit voltage too high. The control unit is reading a higher than normal voltage on the control circuit of vacuum pump A. This usually indicates a broken wire or contact with a power supply. The pump may not be getting the right command.
Can I keep driving with code P258D active?
With caution: limp mode possible, have it checked soon
Common causes — P258D
Control wire broken or connector unplugged Corroded terminals Pump failed Wire in contact with a power supply Control unit fault (rare)
How do you fix code P258D?
Check the pump connector, wiring and relay. If the brakes feel less assisted, do not put off the check.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P258C — Vacuum pump A control circuit voltage too low
- Next code: P258E — PTO enable switch performance problem
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault