P258C — Vacuum pump A control circuit voltage too low
| Meaning | The control unit is reading a lower than normal voltage on the control circuit of vacuum pump A. Usually the wire is grounded or the pump is shorted. The pump may not run or may run poorly. |
| Family | Powertrain (P) |
Typical symptoms
Harder brake pedal
Less assisted braking
Pump fuse blowing
Weak vacuum-operated functions
Common causes
Vacuum pump shorted
Connector with water or corrosion
Relay defective
Control unit fault (rare)
What to do
How to read code P258C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P258C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (8C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P258C mean?
Vacuum pump A control circuit voltage too low. The control unit is reading a lower than normal voltage on the control circuit of vacuum pump A. Usually the wire is grounded or the pump is shorted. The pump may not run or may run poorly.
Can I keep driving with code P258C active?
With caution: limp mode possible, have it checked soon
Common causes — P258C
Control wire grounded by damaged insulation Vacuum pump shorted Connector with water or corrosion Relay defective Control unit fault (rare)
How do you fix code P258C?
Check the pump wiring, connector and fuse. If the brakes feel less assisted, have it checked right away.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P258B — Vacuum pump A control circuit range/performance
- Next code: P258D — Vacuum pump A control circuit voltage too high
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault