P2593 — Turbocharger B speed sensor circuit
| Meaning | The control unit has found an electrical fault in the circuit of the sensor that measures the rotation speed of the second turbocharger (B). Without this signal it cannot properly control boost pressure or protect the turbo from over-speeding. This code applies to engines with two turbos or several boost stages. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power or an engine that feels choked
Slow response to the accelerator
Limp mode with reduced power
Unusual exhaust smoke in some cases
Common causes
Faulty turbo speed sensor
Excess heat that has ruined the wires near the turbo
Worn or damaged turbocharger B
Engine control unit problem (rare)
What to do
How to read code P2593
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2593 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (93) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2593 mean?
Turbocharger B speed sensor circuit. The control unit has found an electrical fault in the circuit of the sensor that measures the rotation speed of the second turbocharger (B). Without this signal it cannot properly control boost pressure or protect the turbo from over-speeding. This code applies to engines with two turbos or several boost stages.
Can I keep driving with code P2593 active?
With caution: limp mode possible, have it checked soon
Common causes — P2593
Damaged or corroded sensor wiring or connector Faulty turbo speed sensor Excess heat that has ruined the wires near the turbo Worn or damaged turbocharger B Engine control unit problem (rare)
How do you fix code P2593?
Have the sensor wiring and connector checked first, as they are the most common cause. You can drive carefully to the workshop, avoiding heavy loads, but do not put it off for long: a turbo running without control can be damaged.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2592 — Cruise control front distance sensor, right side
- Next code: P2594 — Turbo B speed sensor: signal out of range or impla...
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault