P2599 — Turbo A boost control position sensor: stuck high
| Meaning | The control unit has seen that the position sensor controlling turbo A boost stays at a high value and does not follow commands. It may be the sensor reading wrongly or the regulating part stuck in one position. If it stays stuck like this, boost can be too high or unregulated. |
| Family | Powertrain (P) |
Typical symptoms
Boost too high or uneven push
Limp mode with limited power
Noises or whistling from the turbo
Abrupt or jerky accelerator response
Common causes
Faulty actuator that does not return
Disconnected control linkages or hoses
Faulty position sensor
Damaged wiring or connector
What to do
How to read code P2599
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2599 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (99) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2599 mean?
Turbo A boost control position sensor: stuck high. The control unit has seen that the position sensor controlling turbo A boost stays at a high value and does not follow commands. It may be the sensor reading wrongly or the regulating part stuck in one position. If it stays stuck like this, boost can be too high or unregulated.
Can I keep driving with code P2599 active?
With caution: limp mode possible, have it checked soon
Common causes — P2599
Turbo regulation mechanism seized by carbon deposits Faulty actuator that does not return Disconnected control linkages or hoses Faulty position sensor Damaged wiring or connector
How do you fix code P2599?
Have the actuator, linkages and sensor checked soon. Boost that is too high can damage the engine and turbo, so avoid heavy loads and hard acceleration until it is checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2598 — Turbo A boost control position sensor: stuck low
- Next code: P259A — Turbo B boost control position sensor: stuck low
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault