Skip to content
Fault code dictionary (DTC)

P25A1 — Turbo B boost control position at high limit

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit has driven the part that regulates turbo B boost to the end of its maximum travel and still is not getting the requested pressure. This means the system has no more room to correct in that direction. Often actual pressure is lower than requested, for example because of an air leak or a turbo that is not pushing.
FamilyPowertrain (P)

Typical symptoms

Engine warning light on
Little power, especially under load
Turbo that seems not to push
Possible limp mode
Whistling or hissing from the air pipes

Common causes

Air leaks in the pipes, clamps or intercooler
Worn turbo B or damaged blades
Regulation mechanism stuck or dirty
Boost pressure sensor reading wrongly
Faulty actuator or disconnected vacuum hoses

What to do

Have the air pipes and intercooler checked first for leaks, then the actuator and sensor. You can drive with care at reduced power, but do not let much time pass.

How to read code P25A1

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P25A1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (A1) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P25A1 mean?

Turbo B boost control position at high limit. The control unit has driven the part that regulates turbo B boost to the end of its maximum travel and still is not getting the requested pressure. This means the system has no more room to correct in that direction. Often actual pressure is lower than requested, for example because of an air leak or a turbo that is not pushing.

Can I keep driving with code P25A1 active?

With caution: limp mode possible, have it checked soon

Common causes — P25A1

Air leaks in the pipes, clamps or intercooler Worn turbo B or damaged blades Regulation mechanism stuck or dirty Boost pressure sensor reading wrongly Faulty actuator or disconnected vacuum hoses

How do you fix code P25A1?

Have the air pipes and intercooler checked first for leaks, then the actuator and sensor. You can drive with care at reduced power, but do not let much time pass.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes