P25B7 — Auxiliary ignition switch On/Start position circuit fault
| Meaning | The control unit found a problem in the circuit that reports the On/Start position of the auxiliary ignition switch, meaning a second contact tied to the key or start button. The control unit is not getting a reliable signal about when you want to start the engine or keep it running. The code is standard, but the exact circuit depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting or no start
Engine stalling for no reason
Accessories not powered
Inconsistent key/start signal on the dash
Common causes
Switch connector or wiring
Relay or fuse in the circuit
Insufficient power or ground
Fault in the module reading the signal
What to do
How to read code P25B7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P25B7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (B7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P25B7 mean?
Auxiliary ignition switch On/Start position circuit fault. The control unit found a problem in the circuit that reports the On/Start position of the auxiliary ignition switch, meaning a second contact tied to the key or start button. The control unit is not getting a reliable signal about when you want to start the engine or keep it running. The code is standard, but the exact circuit depends on the manufacturer.
Can I keep driving with code P25B7 active?
With caution: limp mode possible, have it checked soon
Common causes — P25B7
Worn ignition switch contacts Switch connector or wiring Relay or fuse in the circuit Insufficient power or ground Fault in the module reading the signal
How do you fix code P25B7?
Check the switch connector, the fuses and the battery condition. If the car will not start or stalls while driving, do not use it and have the circuit checked right away.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P25B6 — Turbo wastegate B: stuck closed
- Next code: P25B8 — Auxiliary ignition switch On/Start position: volta...
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault