P25B8 — Auxiliary ignition switch On/Start position: voltage low
| Meaning | The control unit reads a lower than normal voltage on the circuit that reports the On/Start position of the auxiliary ignition switch. This usually means a wire shorted to ground, a shorted contact, or a missing supply. The start signal may therefore not arrive correctly. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting or no start
Engine suddenly stalling
Accessories not powered
Dash showing inconsistent signals
Common causes
Shorted internal switch contacts
Wet or corroded connector
Missing fuse or circuit supply
Flat battery or low battery voltage
Fault in the module reading the signal (rare)
What to do
How to read code P25B8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P25B8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (B8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P25B8 mean?
Auxiliary ignition switch On/Start position: voltage low. The control unit reads a lower than normal voltage on the circuit that reports the On/Start position of the auxiliary ignition switch. This usually means a wire shorted to ground, a shorted contact, or a missing supply. The start signal may therefore not arrive correctly.
Can I keep driving with code P25B8 active?
With caution: limp mode possible, have it checked soon
Common causes — P25B8
Signal wire touching ground Shorted internal switch contacts Wet or corroded connector Missing fuse or circuit supply Flat battery or low battery voltage Fault in the module reading the signal (rare)
How do you fix code P25B8?
First check the battery, fuses and switch connector. If the car stalls while driving or will not start, do not use it and have the circuit checked right away.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P25B7 — Auxiliary ignition switch On/Start position circui...
- Next code: P25B9 — Auxiliary ignition (ON/Start) circuit: signal high
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault