P25B9 — Auxiliary ignition (ON/Start) circuit: signal high
| Meaning | The control unit detected a voltage that is too high in the auxiliary ignition switch circuit, the one that reports the key's ON or Start position. The signal that should change with the key position is stuck at an abnormally high level. The exact meaning and measuring point depend on the manufacturer, so I can't give you reliable details for a specific brand here. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting or engine that won't start
Sudden engine stalling
Some systems or warning lights behaving oddly when the ignition is switched on
Common causes
Corroded, loose or damaged connector pins
Worn ignition switch or auxiliary contact
Internal fault in the control unit reading the signal
Earlier electrical work (alarm, immobilizer, aftermarket accessories)
What to do
How to read code P25B9
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P25B9 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (B9) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P25B9 mean?
Auxiliary ignition (ON/Start) circuit: signal high. The control unit detected a voltage that is too high in the auxiliary ignition switch circuit, the one that reports the key's ON or Start position. The signal that should change with the key position is stuck at an abnormally high level. The exact meaning and measuring point depend on the manufacturer, so I can't give you reliable details for a specific brand here.
Can I keep driving with code P25B9 active?
With caution: limp mode possible, have it checked soon
Common causes — P25B9
Wiring in this circuit shorted to power Corroded, loose or damaged connector pins Worn ignition switch or auxiliary contact Internal fault in the control unit reading the signal Earlier electrical work (alarm, immobilizer, aftermarket accessories)
How do you fix code P25B9?
First check the connectors and wiring near the ignition switch, and whether any electrical accessory was fitted recently. Don't ignore it for long: if the engine stalls on its own or struggles to start, have the car checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P25B8 — Auxiliary ignition switch On/Start position: volta...
- Next code: P25BA — Regeneration switch: open circuit
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault