Skip to content
Fault code dictionary (DTC)

P25C8 — Brake booster temperature sensor A: intermittent signal

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit receives a signal from the brake booster temperature sensor that comes and goes or jumps erratically. This usually points to an electrical contact that breaks now and then. How it is managed depends on the manufacturer and I have no reliable information for a specific brand.
FamilyPowertrain (P)

Typical symptoms

Check engine light turning on and off
Possible brake-related message that appears now and then
Brake pedal feel that changes
Problem showing up with vibration or after rain
Sometimes no noticeable symptoms

Common causes

Loose connector or poor contact
Partly broken wire in the harness
Moisture getting into the connector
Temperature sensor starting to fail
Control module fault, less common

What to do

Check the connector and wiring, gently moving them to look for loose contacts or signs of moisture. Intermittent faults often need a live test with diagnostic tools, so don't leave it too long.

How to read code P25C8

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P25C8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (C8) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P25C8 mean?

Brake booster temperature sensor A: intermittent signal. The control unit receives a signal from the brake booster temperature sensor that comes and goes or jumps erratically. This usually points to an electrical contact that breaks now and then. How it is managed depends on the manufacturer and I have no reliable information for a specific brand.

Can I keep driving with code P25C8 active?

With caution: limp mode possible, have it checked soon

Common causes — P25C8

Loose connector or poor contact Partly broken wire in the harness Moisture getting into the connector Temperature sensor starting to fail Control module fault, less common

How do you fix code P25C8?

Check the connector and wiring, gently moving them to look for loose contacts or signs of moisture. Intermittent faults often need a live test with diagnostic tools, so don't leave it too long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes