P25CD — Intake cam lock actuator circuit open, bank 2
| Meaning | The engine computer controls a small pin that holds the intake camshaft phaser in its parked position on bank 2. It has detected that the electrical circuit for this control is open or not responding. Without a proper command, the lock may not work as intended. |
| Family | Powertrain (P) |
Typical symptoms
Metallic rattle or ticking on cold start
Rough idle
Reduced response at low rpm
Longer cranking in some cases
Common causes
Broken or damaged wire in the bank 2 harness
Internally failed solenoid or phaser actuator
Poor ground or power supply connection
Engine computer fault, uncommon
What to do
How to read code P25CD
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P25CD starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (CD) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P25CD mean?
Intake cam lock actuator circuit open, bank 2. The engine computer controls a small pin that holds the intake camshaft phaser in its parked position on bank 2. It has detected that the electrical circuit for this control is open or not responding. Without a proper command, the lock may not work as intended.
Can I keep driving with code P25CD active?
With caution: limp mode possible, have it checked soon
Common causes — P25CD
Corroded or poorly seated connector at the phaser solenoid Broken or damaged wire in the bank 2 harness Internally failed solenoid or phaser actuator Poor ground or power supply connection Engine computer fault, uncommon
How do you fix code P25CD?
First check the oil level and condition, then the connector and wiring of the bank 2 actuator. You can drive carefully for short trips, but don't leave it too long, since the phaser depends on oil and a prolonged fault can get worse. Don't clear the code without finding the cause.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P25CC — Intake camshaft actuator park lock control: high (...
- Next code: P25CE — Intake cam lock actuator circuit low, bank 2
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault