P25CE — Intake cam lock actuator circuit low, bank 2
| Meaning | The engine computer measured too low a voltage on the wire that drives the lock pin of the intake camshaft phaser on bank 2. This usually points to a short to ground in the wiring or in the solenoid. The phaser lock may then not work properly. |
| Family | Powertrain (P) |
Typical symptoms
Metallic noise at start-up
Unstable idle
Less response when accelerating
Possible reduced engine performance
Common causes
Shorted phaser solenoid
Connector with moisture or corrosion
Harness rubbing against engine parts
Internal computer fault, uncommon
What to do
How to read code P25CE
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P25CE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (CE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P25CE mean?
Intake cam lock actuator circuit low, bank 2. The engine computer measured too low a voltage on the wire that drives the lock pin of the intake camshaft phaser on bank 2. This usually points to a short to ground in the wiring or in the solenoid. The phaser lock may then not work properly.
Can I keep driving with code P25CE active?
With caution: limp mode possible, have it checked soon
Common causes — P25CE
Pinched or chafed wire touching ground Shorted phaser solenoid Connector with moisture or corrosion Harness rubbing against engine parts Internal computer fault, uncommon
How do you fix code P25CE?
Inspect the wiring and connector of the bank 2 actuator for rubbing, moisture or burn marks. The car can be used carefully for short trips, but have the circuit checked soon. Don't clear the code to make it go away.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P25CD — Intake cam lock actuator circuit open, bank 2
- Next code: P25CF — Intake cam lock actuator circuit high, bank 2
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault