Skip to content
Fault code dictionary (DTC)

P264D — Rocker arm actuator A position sensor circuit high, bank 1

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe computer reads too high a voltage on the circuit of the position sensor for rocker arm actuator A. Usually the signal wire touches a power supply, the sensor ground connection is missing, or the sensor has failed.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Loss of power
Weak acceleration
Rough idle in some cases
Valve system operation limited

Common causes

Signal wire touching a power supply
Sensor ground open or with high resistance
Damaged or corroded connector
Faulty position sensor
Computer fault, which is rare

What to do

Inspect the connector, wiring and ground of the sensor. The car can generally be driven with care, but have it diagnosed soon so the system does not stay out of action.

How to read code P264D

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P264D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (4D) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P264D mean?

Rocker arm actuator A position sensor circuit high, bank 1. The computer reads too high a voltage on the circuit of the position sensor for rocker arm actuator A. Usually the signal wire touches a power supply, the sensor ground connection is missing, or the sensor has failed.

Can I keep driving with code P264D active?

With caution: limp mode possible, have it checked soon

Common causes — P264D

Signal wire touching a power supply Sensor ground open or with high resistance Damaged or corroded connector Faulty position sensor Computer fault, which is rare

How do you fix code P264D?

Inspect the connector, wiring and ground of the sensor. The car can generally be driven with care, but have it diagnosed soon so the system does not stay out of action.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes