P264C — Rocker arm actuator A position sensor circuit low, bank 1
| Meaning | The computer reads too low a voltage on the circuit of the position sensor for rocker arm actuator A. This usually means a signal wire grounded, a missing sensor supply or a failed sensor. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Less responsive engine
Uneven running in some conditions
Valve system shut out by the computer
Common causes
Wet, corroded or loose connector
Faulty position sensor
Interrupted sensor supply
Computer fault, which is rare
What to do
How to read code P264C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P264C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (4C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P264C mean?
Rocker arm actuator A position sensor circuit low, bank 1. The computer reads too low a voltage on the circuit of the position sensor for rocker arm actuator A. This usually means a signal wire grounded, a missing sensor supply or a failed sensor.
Can I keep driving with code P264C active?
With caution: limp mode possible, have it checked soon
Common causes — P264C
Chafed signal wire touching ground Wet, corroded or loose connector Faulty position sensor Interrupted sensor supply Computer fault, which is rare
How do you fix code P264C?
Check the sensor connector and wiring, looking for chafed or wet spots. You can usually drive with care, but do not put the diagnosis off for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P264B — Rocker arm actuator A position sensor range/perfor...
- Next code: P264D — Rocker arm actuator A position sensor circuit high...
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low