P2664 — Bank 2 rocker arm actuator control circuit high
| Meaning | The engine computer reads a voltage that is too high in the control circuit of the rocker arm actuator on bank 2. It may be a short to supply voltage or another fault in the control circuit. The meaning depends on the manufacturer's system. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power in some conditions
Unstable idle
Valve system not managed correctly
Noises from the cylinder head in some cases
Common causes
Damaged or corroded connector
Faulty actuator or solenoid
Wrong oil level or type
Faulty computer driver (rare)
What to do
How to read code P2664
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2664 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (64) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2664 mean?
Bank 2 rocker arm actuator control circuit high. The engine computer reads a voltage that is too high in the control circuit of the rocker arm actuator on bank 2. It may be a short to supply voltage or another fault in the control circuit. The meaning depends on the manufacturer's system.
Can I keep driving with code P2664 active?
With caution: limp mode possible, have it checked soon
Common causes — P2664
Wiring shorted to supply voltage Damaged or corroded connector Faulty actuator or solenoid Wrong oil level or type Faulty computer driver (rare)
How do you fix code P2664?
Start with the connector and wiring of the bank 2 actuator, then test the actuator. Check the oil too. Drive cautiously and don't delay too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2663 — Bank 2 rocker arm actuator control circuit low
- Next code: P2665 — Fuel shutoff valve B control circuit open
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low