P2672 — Injection pump timing offset
| Meaning | The control unit detected that the injection pump timing, meaning the moment it injects relative to engine rotation, is off from the expected value. It applies to diesel engines with an electronically controlled injection pump. The fault can come from how the pump is fitted or from a sensor giving a wrong reading. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting, especially when hot
Black or white smoke from the exhaust
Engine noisier or knocking more than normal
Loss of power
Rough idle
Common causes
Timing belt or chain jumped or stretched
Faulty crankshaft or pump position sensor
Worn injection pump
Damaged sensor wiring or connectors
Timing not reset after a repair
What to do
How to read code P2672
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2672 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (72) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2672 mean?
Injection pump timing offset. The control unit detected that the injection pump timing, meaning the moment it injects relative to engine rotation, is off from the expected value. It applies to diesel engines with an electronically controlled injection pump. The fault can come from how the pump is fitted or from a sensor giving a wrong reading.
Can I keep driving with code P2672 active?
With caution: limp mode possible, have it checked soon
Common causes — P2672
Injection pump fitted or set with incorrect timing Timing belt or chain jumped or stretched Faulty crankshaft or pump position sensor Worn injection pump Damaged sensor wiring or connectors Timing not reset after a repair
How do you fix code P2672?
If the problem appeared after work on the timing or the pump, have the timing marks checked again right away. If the engine knocks or smokes heavily, avoid using the car to prevent damage. A workshop with a diagnostic tool is needed to check the actual timing.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2671 — Actuator supply voltage B circuit high
- Next code: P2673 — Injection pump timing calibration not learned
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low