Skip to content
Fault code dictionary (DTC)

P2673 — Injection pump timing calibration not learned

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit has not yet stored the calibration values for injection pump timing. This usually happens after the pump or control unit has been replaced, or after the battery was disconnected or the memory was cleared. The learning procedure depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Longer than normal cranking
Engine running roughly
Rough idle
Reduced performance or abnormal smoke

Common causes

Pump or control unit recently replaced without the learning procedure
Control unit memory reset
Learning procedure interrupted or not completed
Battery disconnected or flat during a repair
Sensor or wiring preventing the learning

What to do

If work was done recently, have the learning procedure carried out with a diagnostic tool suited to your brand. Simply driving gently will not fix it, as a specific procedure is often needed. If the engine runs well there is no rush, but do not put it off too long.

How to read code P2673

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2673 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (73) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2673 mean?

Injection pump timing calibration not learned. The control unit has not yet stored the calibration values for injection pump timing. This usually happens after the pump or control unit has been replaced, or after the battery was disconnected or the memory was cleared. The learning procedure depends on the manufacturer.

Can I keep driving with code P2673 active?

With caution: limp mode possible, have it checked soon

Common causes — P2673

Pump or control unit recently replaced without the learning procedure Control unit memory reset Learning procedure interrupted or not completed Battery disconnected or flat during a repair Sensor or wiring preventing the learning

How do you fix code P2673?

If work was done recently, have the learning procedure carried out with a diagnostic tool suited to your brand. Simply driving gently will not fix it, as a specific procedure is often needed. If the engine runs well there is no rush, but do not put it off too long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes