Skip to content
Fault code dictionary (DTC)

P2676 — Air cleaner inlet control circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that the control circuit for the air cleaner inlet has too low a voltage, usually because of a short to ground. The component is not being commanded properly. The exact identity of the component depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Slight drop in performance
Unusual noise from the intake
Air control that does not change position
No obvious symptoms in some cases

Common causes

Control wire touching ground
Actuator or solenoid valve shorted
Connector with moisture or dirt
Wiring pinched or chafed
Faulty driver stage in the control unit (rare)

What to do

Inspect the wiring and connector near the air cleaner, looking for pinched wires or damaged insulation. A short circuit can blow the fuse or damage the driver, so it is better not to wait too long. An electrical measurement at a workshop is then needed.

How to read code P2676

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2676 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (76) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2676 mean?

Air cleaner inlet control circuit low. The control unit detected that the control circuit for the air cleaner inlet has too low a voltage, usually because of a short to ground. The component is not being commanded properly. The exact identity of the component depends on the manufacturer.

Can I keep driving with code P2676 active?

With caution: limp mode possible, have it checked soon

Common causes — P2676

Control wire touching ground Actuator or solenoid valve shorted Connector with moisture or dirt Wiring pinched or chafed Faulty driver stage in the control unit (rare)

How do you fix code P2676?

Inspect the wiring and connector near the air cleaner, looking for pinched wires or damaged insulation. A short circuit can blow the fuse or damage the driver, so it is better not to wait too long. An electrical measurement at a workshop is then needed.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes