Skip to content
Fault code dictionary (DTC)

P2675 — Air cleaner inlet control circuit open

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected an open circuit in the control of the air cleaner inlet, the device that manages where the engine takes in air. This means the electrical connection to the component is broken or not responding. Exactly which component it is depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Slight loss of performance
Intake noise different from usual
Engine breathing poorly when cold or at high temperature
No obvious symptoms in some cases

Common causes

Connector unplugged or with corroded contacts
Control wire broken
Faulty air inlet actuator or solenoid valve
Missing fuse or supply for the control
Fault in the control unit's driver (rare)

What to do

Check that the component's connector on the air cleaner housing is fully seated and free of moisture, then look at the condition of the wires. If all is well, an electrical test at a workshop is needed. It is usually not urgent, but it should be fixed to keep the engine properly supplied with air.

How to read code P2675

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2675 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (75) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2675 mean?

Air cleaner inlet control circuit open. The control unit detected an open circuit in the control of the air cleaner inlet, the device that manages where the engine takes in air. This means the electrical connection to the component is broken or not responding. Exactly which component it is depends on the manufacturer.

Can I keep driving with code P2675 active?

With caution: limp mode possible, have it checked soon

Common causes — P2675

Connector unplugged or with corroded contacts Control wire broken Faulty air inlet actuator or solenoid valve Missing fuse or supply for the control Fault in the control unit's driver (rare)

How do you fix code P2675?

Check that the component's connector on the air cleaner housing is fully seated and free of moisture, then look at the condition of the wires. If all is well, an electrical test at a workshop is needed. It is usually not urgent, but it should be fixed to keep the engine properly supplied with air.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes