P2680 — Coolant degassing valve control circuit high
| Meaning | The control unit detected that the control circuit for the coolant degassing valve has too high a voltage, usually due to contact with a supply voltage or a fault in the driver. The valve does not respond correctly and air may stay in the system. |
| Family | Powertrain (P) |
Typical symptoms
Unstable coolant temperature
Irregular cabin heating
Coolant level that varies
Possible overheating in serious cases
Common causes
Faulty degassing valve
Damaged connector or moisture inside it
Worn or chafed wiring
Faulty driver stage in the control unit (rare)
What to do
How to read code P2680
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2680 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (80) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2680 mean?
Coolant degassing valve control circuit high. The control unit detected that the control circuit for the coolant degassing valve has too high a voltage, usually due to contact with a supply voltage or a fault in the driver. The valve does not respond correctly and air may stay in the system.
Can I keep driving with code P2680 active?
With caution: limp mode possible, have it checked soon
Common causes — P2680
Control wire touching a supply voltage Faulty degassing valve Damaged connector or moisture inside it Worn or chafed wiring Faulty driver stage in the control unit (rare)
How do you fix code P2680?
Check the coolant level with the engine cold and keep an eye on the temperature while driving. If it climbs too high, stop right away. Then have the wiring, connector and valve inspected at a workshop.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P267F — Control module internal temperature sensor A circu...
- Next code: P2681 — Coolant bypass valve A: control circuit fault
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low