P267F — Control module internal temperature sensor A circuit intermittent
| Meaning | The control unit detected that its own internal temperature sensor A gives a reading that drops in and out or jumps erratically. This sensor monitors the heat of the internal electronics. Which module is involved and how it reacts depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Occasional irregular operation
Possible temporary limits on some functions
Other codes related to the control unit
No obvious symptoms in many cases
Common causes
Control unit connector with corroded or loose contacts
Unstable control unit ground or supply
Moisture or water ingress in the control unit
Weak battery or unstable system voltage
Damaged main wiring
What to do
How to read code P267F
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P267F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (7F) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P267F mean?
Control module internal temperature sensor A circuit intermittent. The control unit detected that its own internal temperature sensor A gives a reading that drops in and out or jumps erratically. This sensor monitors the heat of the internal electronics. Which module is involved and how it reacts depends on the manufacturer.
Can I keep driving with code P267F active?
With caution: limp mode possible, have it checked soon
Common causes — P267F
Internal fault in the sensor or control unit Control unit connector with corroded or loose contacts Unstable control unit ground or supply Moisture or water ingress in the control unit Weak battery or unstable system voltage Damaged main wiring
How do you fix code P267F?
First check the battery, terminals and grounds, because unstable voltage can cause odd readings. Also check for any moisture on the control unit connector. If the code returns, a workshop diagnosis is needed. It is usually not urgent, but should not be ignored.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P267E — Rocker arm actuator position sensor B circuit inte...
- Next code: P2680 — Coolant degassing valve control circuit high
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low