Skip to content
Fault code dictionary (DTC)

P2697 — Exhaust fuel injector A: open circuit

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detects no electrical continuity in the circuit of the injector that sprays fuel into the exhaust to regenerate the particulate filter. The circuit is broken, so the injector cannot be commanded.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Particulate filter regeneration not starting
Particulate filter warning light on
Loss of power
More exhaust smoke or smell
Engine running in reduced-power mode

Common causes

Injector connector loose or corroded
Wire broken or damaged by heat
Injector with a broken internal coil
Fault in the control unit's injector driver
Blown fuse or missing power supply

What to do

First have the connector and wiring near the exhaust checked, because heat damages cables there. If the filter cannot regenerate, it gradually clogs, so it is not wise to wait too long.

How to read code P2697

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2697 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (97) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2697 mean?

Exhaust fuel injector A: open circuit. The control unit detects no electrical continuity in the circuit of the injector that sprays fuel into the exhaust to regenerate the particulate filter. The circuit is broken, so the injector cannot be commanded.

Can I keep driving with code P2697 active?

With caution: limp mode possible, have it checked soon

Common causes — P2697

Injector connector loose or corroded Wire broken or damaged by heat Injector with a broken internal coil Fault in the control unit's injector driver Blown fuse or missing power supply

How do you fix code P2697?

First have the connector and wiring near the exhaust checked, because heat damages cables there. If the filter cannot regenerate, it gradually clogs, so it is not wise to wait too long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes