Skip to content
Fault code dictionary (DTC)

P269D — Exhaust glow plug control: circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit measures a lower voltage than expected on the exhaust glow plug control circuit. This usually points to a wire shorted to ground, or a fault in the control module.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Particulate filter regeneration not starting
Particulate filter warning light on
Loss of power
Possible blown fuse

Common causes

Wire with damaged insulation touching ground
Wet or corroded connector
Faulty control module or relay
Glow plug with a short circuit
Fault in the control unit

What to do

Have the control wiring and connector checked, especially near the exhaust. Filter regeneration may be compromised, so do not wait too long.

How to read code P269D

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P269D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (9D) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P269D mean?

Exhaust glow plug control: circuit low. The control unit measures a lower voltage than expected on the exhaust glow plug control circuit. This usually points to a wire shorted to ground, or a fault in the control module.

Can I keep driving with code P269D active?

With caution: limp mode possible, have it checked soon

Common causes — P269D

Wire with damaged insulation touching ground Wet or corroded connector Faulty control module or relay Glow plug with a short circuit Fault in the control unit

How do you fix code P269D?

Have the control wiring and connector checked, especially near the exhaust. Filter regeneration may be compromised, so do not wait too long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes