Skip to content
Fault code dictionary (DTC)

P26A1 — Exhaust glow plug: circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit measures a lower voltage than expected on the exhaust glow plug circuit. This usually points to a short to ground in the wiring or in the glow plug itself.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Particulate filter regeneration not starting
Particulate filter warning light on
Loss of power
Possible blown fuse

Common causes

Wire with damaged insulation touching ground
Wet or corroded connector
Shorted glow plug
Fault in the control
Wiring crushed or burned

What to do

Have the wiring, connector and glow plug checked in the exhaust area. The filter may not regenerate, so it is better to act soon.

How to read code P26A1

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P26A1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (A1) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P26A1 mean?

Exhaust glow plug: circuit low. The control unit measures a lower voltage than expected on the exhaust glow plug circuit. This usually points to a short to ground in the wiring or in the glow plug itself.

Can I keep driving with code P26A1 active?

With caution: limp mode possible, have it checked soon

Common causes — P26A1

Wire with damaged insulation touching ground Wet or corroded connector Shorted glow plug Fault in the control Wiring crushed or burned

How do you fix code P26A1?

Have the wiring, connector and glow plug checked in the exhaust area. The filter may not regenerate, so it is better to act soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes