Skip to content
Fault code dictionary (DTC)

P26A6 — Bypass valve A position sensor: circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit measures a lower voltage than expected on the coolant bypass valve position sensor circuit. This usually points to a wire shorted to ground, a broken wire or a faulty sensor.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Abnormal engine temperature
Weak cabin heating
Cooling fan running all the time
Unusual fuel consumption

Common causes

Signal wire touching ground
Broken wire or loose connector
Faulty position sensor
Missing sensor power supply
Fault in the control unit

What to do

Have the wiring, connector and sensor power supply checked. In the meantime watch the engine temperature and do not ignore the problem for long.

How to read code P26A6

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P26A6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (A6) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P26A6 mean?

Bypass valve A position sensor: circuit low. The control unit measures a lower voltage than expected on the coolant bypass valve position sensor circuit. This usually points to a wire shorted to ground, a broken wire or a faulty sensor.

Can I keep driving with code P26A6 active?

With caution: limp mode possible, have it checked soon

Common causes — P26A6

Signal wire touching ground Broken wire or loose connector Faulty position sensor Missing sensor power supply Fault in the control unit

How do you fix code P26A6?

Have the wiring, connector and sensor power supply checked. In the meantime watch the engine temperature and do not ignore the problem for long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes