P2719 — Pressure control solenoid D control circuit range/performance
| Meaning | The control unit detected that the control signal of pressure control solenoid D is outside the expected range or doesn't behave as it should. It can come from the electrical system or from the valve itself. The role of valve D depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Occasional slipping
Transmission warning light on
Gearbox in limp mode
Irregular shift pressure felt
Common causes
Solenoid with wear or altered coil
Unstable gearbox supply or ground
Dirty gearbox fluid disturbing the valve
Weak battery or irregular voltage
Faulty transmission control unit, rare
What to do
How to read code P2719
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2719 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (19) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2719 mean?
Pressure control solenoid D control circuit range/performance. The control unit detected that the control signal of pressure control solenoid D is outside the expected range or doesn't behave as it should. It can come from the electrical system or from the valve itself. The role of valve D depends on the manufacturer.
Can I keep driving with code P2719 active?
With caution: limp mode possible, have it checked soon
Common causes — P2719
Abnormal resistance in the wiring or connector Solenoid with wear or altered coil Unstable gearbox supply or ground Dirty gearbox fluid disturbing the valve Weak battery or irregular voltage Faulty transmission control unit, rare
How do you fix code P2719?
First check the battery voltage, connectors and gearbox wiring, then the fluid condition. If the gearbox slips, limit use until it has been checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2718 — Pressure control solenoid D control circuit open
- Next code: P271A — Park pawl position sensor A circuit low
Related codes
- P2700 — Transmission friction element A apply time out of range
- P2701 — Transmission friction element B apply time out of range
- P2702 — Transmission friction element C apply time out of range
- P2703 — Transmission friction element D apply time out of range
- P2704 — Transmission friction element E apply time out of range
- P2705 — Transmission friction element F apply time out of range
- P2706 — Shift solenoid F: general fault
- P2707 — Shift solenoid F: performance or stuck off
- P2708 — Shift solenoid F: stuck on
- P2709 — Shift solenoid F: electrical fault
- P270A — Transmission friction element A temperature too high
- P270B — Transmission friction element B temperature too high