P271A — Park pawl position sensor A circuit low
| Meaning | The control unit detected a signal that is too low from sensor A, which reports the position of the park pawl (the latch that locks the gearbox in P). Without a reliable signal, the system doesn't know whether the car is really locked. Which sensor is physically called A depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Difficulty engaging or leaving P
Car not starting or not holding well in P
Wrong gear indication on the display
Gearbox in limp mode
Common causes
Wiring shorted to ground or broken
Corroded connector or water in it
Park pawl actuator out of position
Missing supply to the sensor
Faulty control unit, rare
What to do
How to read code P271A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P271A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (1A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P271A mean?
Park pawl position sensor A circuit low. The control unit detected a signal that is too low from sensor A, which reports the position of the park pawl (the latch that locks the gearbox in P). Without a reliable signal, the system doesn't know whether the car is really locked. Which sensor is physically called A depends on the manufacturer.
Can I keep driving with code P271A active?
With caution: limp mode possible, have it checked soon
Common causes — P271A
Faulty sensor Wiring shorted to ground or broken Corroded connector or water in it Park pawl actuator out of position Missing supply to the sensor Faulty control unit, rare
How do you fix code P271A?
Have the sensor, wiring and connector checked. Until it is fixed, don't rely on P alone: always use the parking brake too, especially on a slope.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2719 — Pressure control solenoid D control circuit range/...
- Next code: P271B — Park pawl position sensor A circuit high
Related codes
- P2700 — Transmission friction element A apply time out of range
- P2701 — Transmission friction element B apply time out of range
- P2702 — Transmission friction element C apply time out of range
- P2703 — Transmission friction element D apply time out of range
- P2704 — Transmission friction element E apply time out of range
- P2705 — Transmission friction element F apply time out of range
- P2706 — Shift solenoid F: general fault
- P2707 — Shift solenoid F: performance or stuck off
- P2708 — Shift solenoid F: stuck on
- P2709 — Shift solenoid F: electrical fault
- P270A — Transmission friction element A temperature too high
- P270B — Transmission friction element B temperature too high