P271B — Park pawl position sensor A circuit high
| Meaning | The control unit detected a signal that is too high from sensor A of the park pawl position, the latch that locks the gearbox in P. The system therefore can't reliably confirm the state of the lock. Which sensor is called A depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Trouble engaging or leaving P
Wrong gear indication on the display
Start refused or uncertain
Gearbox in limp mode
Common causes
Wiring shorted to supply voltage
Damaged or corroded connector
Broken sensor ground wire
Park pawl actuator loose or out of position
Faulty control unit, rare
What to do
How to read code P271B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P271B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (1B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P271B mean?
Park pawl position sensor A circuit high. The control unit detected a signal that is too high from sensor A of the park pawl position, the latch that locks the gearbox in P. The system therefore can't reliably confirm the state of the lock. Which sensor is called A depends on the manufacturer.
Can I keep driving with code P271B active?
With caution: limp mode possible, have it checked soon
Common causes — P271B
Faulty sensor Wiring shorted to supply voltage Damaged or corroded connector Broken sensor ground wire Park pawl actuator loose or out of position Faulty control unit, rare
How do you fix code P271B?
Have the sensor, ground and wiring checked. In the meantime always use the parking brake as well as P, because the lock may not be reliable.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P271A — Park pawl position sensor A circuit low
- Next code: P271C — Park pawl position sensor B circuit low
Related codes
- P2700 — Transmission friction element A apply time out of range
- P2701 — Transmission friction element B apply time out of range
- P2702 — Transmission friction element C apply time out of range
- P2703 — Transmission friction element D apply time out of range
- P2704 — Transmission friction element E apply time out of range
- P2705 — Transmission friction element F apply time out of range
- P2706 — Shift solenoid F: general fault
- P2707 — Shift solenoid F: performance or stuck off
- P2708 — Shift solenoid F: stuck on
- P2709 — Shift solenoid F: electrical fault
- P270A — Transmission friction element A temperature too high
- P270B — Transmission friction element B temperature too high