P28C6 — Clutch A motor U-V-W phase circuit: open circuit
| Meaning | The control unit finds no electrical continuity on one or more of the three phases of the clutch A motor. It may be a broken wire, an unplugged connector, or an open winding inside the motor. Without all three phases the motor will not turn, or turns badly. Which clutch is called A depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Clutch not responding to commands
Car does not start or starts with difficulty
Gearbox stuck in neutral or a single gear
Intermittent behaviour linked to vibration
Transmission fault message
Common causes
Broken or corroded phase wire
Open winding in the electric motor
Worn or pushed-back connector pins
Faulty transmission control module
Moisture that has corroded the contacts
What to do
How to read code P28C6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P28C6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (C6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P28C6 mean?
Clutch A motor U-V-W phase circuit: open circuit. The control unit finds no electrical continuity on one or more of the three phases of the clutch A motor. It may be a broken wire, an unplugged connector, or an open winding inside the motor. Without all three phases the motor will not turn, or turns badly. Which clutch is called A depends on the manufacturer.
Can I keep driving with code P28C6 active?
With caution: limp mode possible, have it checked soon
Common causes — P28C6
Loose or unplugged clutch motor connector Broken or corroded phase wire Open winding in the electric motor Worn or pushed-back connector pins Faulty transmission control module Moisture that has corroded the contacts
How do you fix code P28C6?
First check that the clutch motor connector is seated properly and free of corrosion, then have the continuity of the three phases measured. If the car stays in neutral or will not move, do not force it: it needs a workshop check.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P28C5 — Clutch A motor U-V-W phase circuit: signal too hig...
- Next code: P28C7 — Clutch A motor U-V-W phase: performance not as exp...
Related codes
- P2800 — Range sensor B circuit (PRNDL input) fault
- P2801 — Range sensor B circuit: implausible signal
- P2802 — Range sensor B circuit: signal too low
- P2803 — Range sensor B circuit: signal too high
- P2804 — Range sensor B circuit: intermittent signal
- P2805 — Range sensors A and B: signals do not agree
- P2806 — Transmission range sensor: misalignment
- P2807 — Pressure control solenoid G circuit fault
- P2808 — Pressure solenoid G: performance fault or stuck off
- P2809 — Pressure solenoid G: stuck on
- P280A — Range sensor A circuit: not learned
- P280B — Transmission range sensor B: not learned