P28C7 — Clutch A motor U-V-W phase: performance not as expected
| Meaning | The control unit commanded the clutch A motor and saw that the response of the three phases is not what it expected, without a clear short or open circuit. The motor may be weak, slow or uneven. The code describes the behaviour and does not by itself name the failed part. What clutch A means can differ between brands. |
| Family | Powertrain (P) |
Typical symptoms
Slow or delayed engagement
Jerks or vibration when pulling away
Clutch that seems to slip
Gearbox entering safe mode
Unusual noises from the clutch assembly
Common causes
Abnormal resistance in a connector or wire
Insufficient battery voltage
Stiff or slow clutch actuating mechanism
Control module with a degraded power stage
Transmission oil or lubrication not in proper condition
What to do
How to read code P28C7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P28C7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (C7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P28C7 mean?
Clutch A motor U-V-W phase: performance not as expected. The control unit commanded the clutch A motor and saw that the response of the three phases is not what it expected, without a clear short or open circuit. The motor may be weak, slow or uneven. The code describes the behaviour and does not by itself name the failed part. What clutch A means can differ between brands.
Can I keep driving with code P28C7 active?
With caution: limp mode possible, have it checked soon
Common causes — P28C7
Worn or weak clutch electric motor Abnormal resistance in a connector or wire Insufficient battery voltage Stiff or slow clutch actuating mechanism Control module with a degraded power stage Transmission oil or lubrication not in proper condition
How do you fix code P28C7?
Have the battery and the motor connectors checked, then the motor response with a diagnostic tool. Avoid demanding driving and towing until it is clarified.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P28C6 — Clutch A motor U-V-W phase circuit: open circuit
- Next code: P28C8 — Clutch A hydraulic pump motor: performance not as...
Related codes
- P2800 — Range sensor B circuit (PRNDL input) fault
- P2801 — Range sensor B circuit: implausible signal
- P2802 — Range sensor B circuit: signal too low
- P2803 — Range sensor B circuit: signal too high
- P2804 — Range sensor B circuit: intermittent signal
- P2805 — Range sensors A and B: signals do not agree
- P2806 — Transmission range sensor: misalignment
- P2807 — Pressure control solenoid G circuit fault
- P2808 — Pressure solenoid G: performance fault or stuck off
- P2809 — Pressure solenoid G: stuck on
- P280A — Range sensor A circuit: not learned
- P280B — Transmission range sensor B: not learned