P2A38 — O2 sensor bank 1 sensor 3: positive current control circuit open
| Meaning | The control unit detected an open circuit in the positive current control line of a wide-band oxygen sensor: the third sensor on bank 1, usually the one furthest downstream in the exhaust. The wire or connection to the sensor is broken. The control unit therefore cannot read the mixture properly at that point. |
| Family | Powertrain (P) |
Typical symptoms
Higher than normal fuel consumption
Rough idle
Failed emissions test
Slightly reduced response when accelerating
Common causes
Wire broken or damaged by exhaust heat
Internally faulty oxygen sensor
Wiring damaged by rubbing
Fault in the engine control unit
What to do
How to read code P2A38
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2A38 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (38) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2A38 mean?
O2 sensor bank 1 sensor 3: positive current control circuit open. The control unit detected an open circuit in the positive current control line of a wide-band oxygen sensor: the third sensor on bank 1, usually the one furthest downstream in the exhaust. The wire or connection to the sensor is broken. The control unit therefore cannot read the mixture properly at that point.
Can I keep driving with code P2A38 active?
With caution: limp mode possible, have it checked soon
Common causes — P2A38
Sensor connector unplugged or corroded Wire broken or damaged by exhaust heat Internally faulty oxygen sensor Wiring damaged by rubbing Fault in the engine control unit
How do you fix code P2A38?
First check the wiring and connector of sensor 3 on bank 1, then the sensor itself. You can use the car, but a faulty sensor can worsen emissions and over time stress the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2A37 — Alt. fuel control module power relay: sense circui...
- Next code: P2A39 — O2 sensor bank 1 sensor 3: positive current contro...
Related codes
- P2A00 — O2 sensor circuit range/performance, bank 1 sensor 1
- P2A01 — O2 sensor circuit range/performance, bank 1 sensor 2
- P2A02 — O2 sensor circuit range/performance, bank 1 sensor 3
- P2A03 — O2 sensor circuit range/performance, bank 2 sensor 1
- P2A04 — Bank 2 Sensor 2 oxygen sensor signal not plausible
- P2A05 — Bank 2 Sensor 3 oxygen sensor signal not plausible
- P2A06 — Bank 1 Sensor 1 oxygen sensor negative voltage
- P2A07 — Bank 1 Sensor 2 oxygen sensor negative voltage
- P2A08 — Bank 1 Sensor 3 oxygen sensor negative voltage
- P2A09 — Bank 2 Sensor 1 oxygen sensor negative voltage
- P2A0A — Manifold pressure sensor B circuit fault
- P2A0B — Manifold pressure sensor B signal not plausible