P2A39 — O2 sensor bank 1 sensor 3: positive current control circuit low
| Meaning | The control unit detected a voltage that is too low in the positive current control line of the third oxygen sensor on bank 1. The control wire is probably being pulled toward ground. As a result the control unit cannot read the mixture correctly at that point in the exhaust. |
| Family | Powertrain (P) |
Typical symptoms
Higher than normal fuel consumption
Rough idle
Failed emissions test
Less smooth running under load
Common causes
Corroded or wet sensor connector
Faulty oxygen sensor
Wiring with insulation damaged by heat
Fault in the engine control unit
What to do
How to read code P2A39
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2A39 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (39) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2A39 mean?
O2 sensor bank 1 sensor 3: positive current control circuit low. The control unit detected a voltage that is too low in the positive current control line of the third oxygen sensor on bank 1. The control wire is probably being pulled toward ground. As a result the control unit cannot read the mixture correctly at that point in the exhaust.
Can I keep driving with code P2A39 active?
With caution: limp mode possible, have it checked soon
Common causes — P2A39
Control wire shorted to ground Corroded or wet sensor connector Faulty oxygen sensor Wiring with insulation damaged by heat Fault in the engine control unit
How do you fix code P2A39?
Have the wiring and connector of sensor 3 on bank 1 checked, then the sensor. It will not stop the car, but don't leave it for long because of emissions and the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2A38 — O2 sensor bank 1 sensor 3: positive current contro...
- Next code: P2A3A — O2 sensor bank 1 sensor 3: positive current contro...
Related codes
- P2A00 — O2 sensor circuit range/performance, bank 1 sensor 1
- P2A01 — O2 sensor circuit range/performance, bank 1 sensor 2
- P2A02 — O2 sensor circuit range/performance, bank 1 sensor 3
- P2A03 — O2 sensor circuit range/performance, bank 2 sensor 1
- P2A04 — Bank 2 Sensor 2 oxygen sensor signal not plausible
- P2A05 — Bank 2 Sensor 3 oxygen sensor signal not plausible
- P2A06 — Bank 1 Sensor 1 oxygen sensor negative voltage
- P2A07 — Bank 1 Sensor 2 oxygen sensor negative voltage
- P2A08 — Bank 1 Sensor 3 oxygen sensor negative voltage
- P2A09 — Bank 2 Sensor 1 oxygen sensor negative voltage
- P2A0A — Manifold pressure sensor B circuit fault
- P2A0B — Manifold pressure sensor B signal not plausible