P2A57 — Vaporizer B outlet temperature sensor signal too low
| Meaning | The control unit reads too low a voltage on the circuit of the vaporizer B outlet temperature sensor. In practice the signal behaves as if it were shorted to ground, or the sensor reports an unrealistic temperature. Which unit is vaporizer B is set by the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Automatic return to petrol
Irregular starting or running on gas
Gas system will not engage
Possible protection mode with limited operation
Common causes
Wet or corroded connector
Internally faulty temperature sensor
Wiring pinched against the body or the vaporizer
Faulty alternative fuel control unit
What to do
How to read code P2A57
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2A57 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (57) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2A57 mean?
Vaporizer B outlet temperature sensor signal too low. The control unit reads too low a voltage on the circuit of the vaporizer B outlet temperature sensor. In practice the signal behaves as if it were shorted to ground, or the sensor reports an unrealistic temperature. Which unit is vaporizer B is set by the manufacturer.
Can I keep driving with code P2A57 active?
With caution: limp mode possible, have it checked soon
Common causes — P2A57
Signal wire shorted to ground Wet or corroded connector Internally faulty temperature sensor Wiring pinched against the body or the vaporizer Faulty alternative fuel control unit
How do you fix code P2A57?
Check the sensor wiring along its route, especially where it passes close to metal or hot parts, and the connector. A technician can measure the signal voltage with the sensor unplugged to tell whether the fault is in the wire or the sensor. Meanwhile, drive on petrol.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2A56 — Vaporizer B outlet temperature reading implausible
- Next code: P2A58 — Vaporizer B outlet temperature sensor signal too h...
Related codes
- P2A00 — O2 sensor circuit range/performance, bank 1 sensor 1
- P2A01 — O2 sensor circuit range/performance, bank 1 sensor 2
- P2A02 — O2 sensor circuit range/performance, bank 1 sensor 3
- P2A03 — O2 sensor circuit range/performance, bank 2 sensor 1
- P2A04 — Bank 2 Sensor 2 oxygen sensor signal not plausible
- P2A05 — Bank 2 Sensor 3 oxygen sensor signal not plausible
- P2A06 — Bank 1 Sensor 1 oxygen sensor negative voltage
- P2A07 — Bank 1 Sensor 2 oxygen sensor negative voltage
- P2A08 — Bank 1 Sensor 3 oxygen sensor negative voltage
- P2A09 — Bank 2 Sensor 1 oxygen sensor negative voltage
- P2A0A — Manifold pressure sensor B circuit fault
- P2A0B — Manifold pressure sensor B signal not plausible