Skip to content
Fault code dictionary (DTC)

P2A58 — Vaporizer B outlet temperature sensor signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit reads too high a voltage on the circuit of the vaporizer B outlet temperature sensor. This usually means a broken wire, an unplugged connector or a short to supply voltage, and less often a failed sensor. Which unit is vaporizer B is set by the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Forced switch to petrol
Alternative fuel is not used
Hard starting on gas
Rough running until the system goes into protection

Common causes

Sensor connector unplugged or with worn terminals
Broken wire in the harness
Faulty temperature sensor
Signal wire shorted to supply voltage
Poor sensor ground
Faulty control unit

What to do

First make sure the sensor connector is fully seated and free of corrosion, then check the wires for continuity. This fault is often a wiring problem but should be confirmed by measurement. Use petrol until the system has been checked.

How to read code P2A58

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2A58 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (58) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2A58 mean?

Vaporizer B outlet temperature sensor signal too high. The control unit reads too high a voltage on the circuit of the vaporizer B outlet temperature sensor. This usually means a broken wire, an unplugged connector or a short to supply voltage, and less often a failed sensor. Which unit is vaporizer B is set by the manufacturer.

Can I keep driving with code P2A58 active?

With caution: limp mode possible, have it checked soon

Common causes — P2A58

Sensor connector unplugged or with worn terminals Broken wire in the harness Faulty temperature sensor Signal wire shorted to supply voltage Poor sensor ground Faulty control unit

How do you fix code P2A58?

First make sure the sensor connector is fully seated and free of corrosion, then check the wires for continuity. This fault is often a wiring problem but should be confirmed by measurement. Use petrol until the system has been checked.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes