Skip to content
Fault code dictionary (DTC)

U0291 — Lost communication with gear shift control module B

Severity: Serious Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit no longer receives messages from the second module that handles gear selection, meaning the lever, selector or electronic shift actuator. With shift-by-wire controls there is no mechanical link, so communication is essential. The letter B shows there is more than one such module, and which one it is depends on the manufacturer.
FamilyNetwork (U)

Typical symptoms

Unable to select a gear or Park
Error message on the gear display
Transmission or general warning light on
Gearbox stuck in a gear or in neutral
Car will not start or shut down properly

Common causes

Damaged selector wiring or connector
Weak 12-volt battery
Unstable supply to the module
Faulty module fuse
Failed selector module or actuator
Data bus problem

What to do

This fault can prevent you from moving or parking the car safely, so take it seriously. Check the 12-volt battery straight away and, if the selector does not respond, do not force it. Have a workshop inspect the system before returning to normal use.

How to read code U0291

This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.

The code U0291 starts with U: it belongs to the network and communication between control units area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code U0291 mean?

Lost communication with gear shift control module B. The control unit no longer receives messages from the second module that handles gear selection, meaning the lever, selector or electronic shift actuator. With shift-by-wire controls there is no mechanical link, so communication is essential. The letter B shows there is more than one such module, and which one it is depends on the manufacturer.

Can I keep driving with code U0291 active?

With caution: limp mode possible, have it checked soon

Common causes — U0291

Damaged selector wiring or connector Weak 12-volt battery Unstable supply to the module Faulty module fuse Failed selector module or actuator Data bus problem

How do you fix code U0291?

This fault can prevent you from moving or parking the car safely, so take it seriously. Check the 12-volt battery straight away and, if the selector does not respond, do not force it. Have a workshop inspect the system before returning to normal use.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes