U0435 — Invalid data from rear power steering control module
| Meaning | The control unit received invalid data from the rear steering module, the system that also steers the rear wheels. The module is communicating, but the values are not believable. This system is fitted only to some models and how it works depends on the manufacturer. |
| Family | Network (U) |
Typical symptoms
Rear steering disabled or locked
Wider turning circle than usual at low speed
Car less stable at high speed
Error messages on the dashboard
Common causes
Faulty rear module connector or wiring
Rear steering position sensor giving wrong data
Internal fault in the module
Damaged rear steering actuator
Problem on the communication network
What to do
How to read code U0435
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code U0435 starts with U: it belongs to the network and communication between control units area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code U0435 mean?
Invalid data from rear power steering control module. The control unit received invalid data from the rear steering module, the system that also steers the rear wheels. The module is communicating, but the values are not believable. This system is fitted only to some models and how it works depends on the manufacturer.
Can I keep driving with code U0435 active?
With caution: limp mode possible, have it checked soon
Common causes — U0435
Low or unstable supply voltage Faulty rear module connector or wiring Rear steering position sensor giving wrong data Internal fault in the module Damaged rear steering actuator Problem on the communication network
How do you fix code U0435?
Check the battery and the rear module connectors, then read the other steering codes. If rear steering is out of action, the car responds differently: drive carefully, avoid high speeds and have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: U0434 — Invalid data from active roll control module
- Next code: U0436 — Invalid data from front differential control modul...
Related codes
- U0400 — Invalid Data Received from Network
- U0401 — Invalid Data Received From Engine Control Module
- U0402 — Invalid Data Received From Transmission Control Module
- U0403 — U0403 – Invalid data from transfer case control module
- U0404 — U0404 – Invalid data from gear shift control module
- U0405 — U0405 – Invalid data from cruise control module
- U0406 — U0406 – Invalid data from fuel injector control module
- U0407 — U0407 – Invalid data from glow plug control module
- U0408 — U0408 – Invalid data from throttle actuator control module
- U0409 — U0409 – Invalid data from alternative fuel control module
- U040A — U040A – Invalid data from air conditioning control module
- U040B — U040B – Invalid data from EGR control module A